Configure Video Inputs

You might need to configure video input settings for your RealPresence ITP system.

Procedure

  1. Go to Admin Settings > Audio / Video / Content > Video Inputs.

    Note the three tabs, labeled Left, Main, and Right, that control video input details for the left, main, and right codecs.

  2. If necessary, select a Power Frequency setting for each codec.

    The Power Frequency setting specifies the power line frequency for your system.

  3. In most cases, the system defaults to the correct power line frequency, based on the video standard used in the country where the system is located.

    This setting enables you to adapt the system in areas where the power line frequency does not match the video standard used. You might need to change this setting to avoid flicker caused by lighting.

  4. Select one of the following settings:
    • Save Energy: The camera goes into Standby mode to save resources.
    • Fast Wake Up: The camera wakes faster. This mode is recommended when the user is not concerned about power consumption and does not want to see the blue screen when the system wakes up.