Integrating with a Polycom Video System

The Pano system can send content to a Polycom video system. Once your preferred setup is complete, content sharing is enabled; the Pano system detects when content is available and automatically presents it to the Polycom video system.

You can pair a Pano system with a Polycom video system using two or three monitors:

  • Two Monitors Configure the Pano system and Polycom video system to present content on the second monitor.
  • Three Monitors Integrate the Pano system with the Polycom video system and configure the Pano system to present content on the third monitor. For this setup, the Pano system content displays on two monitors.

Remember the following when enabling content on a Polycom video system:

  • The Pano system must be used to share content during a meeting.
  • Far-end annotations on content from the Pano system are not supported.
  • Make sure you disable the VisualBoard application in the system web interface.
  • The maximum resolution for content shared through a Polycom® RealPresence® Group Series system is 720p.

Polycom recommends the following when integrating your Pano system with a Polycom video system:

  • Create a printout with the Pano system connection information (device name, security code, and enabled connection methods) for users who want to connect their device. Alternatively, you can go to the Polycom video system web interface and select the Content, then Near monitor profile to view the Pano system.
  • Do not display the IP address on the Polycom video system local interface. This prevents users with personal devices from using that IP address to connect to the Pano system.