Mount the System on a Wall

You can mount the Pano system on a wall.

Prerequisite

Before you begin, make sure all cables are disconnected from the system.

image text

Procedure

  1. Attach the two shoulder screws from the mounting kit to the bottom of the system.
  2. Draw a horizontal line on the wall to indicate the location of the mounting plate.
    The line must be level to ensure the system is properly installed. Use a level, if necessary.
  3. Add the screws:
    1. Drill four 4.8 mm holes in the desired location on the wall where you want to position the system. These holes should be horizontal and vertical in alignment with the holes on the mounting plate. Insert expanding tubes into the four holes.
    2. Using a #2 Phillips screwdriver and the screws in the mounting kit, screw the mounting plate to the wall.
  4. With the back panel facing up, insert the heads of the two shoulder screws on the system into the corresponding holes on the mounting plate. Then, gently push the device down until you hear a lock that indicates the system is secure.
  5. Connect the cables, making sure to position them so that they are kept neatly in place and away from heavy foot traffic to prevent accidental cable disconnections or damage.