Complete the Two-Monitor Setup (Direct Connection)

The following instructions describe how to directly connect your Pano system, Polycom video system, and two monitors.

Procedure

  1. Make sure that the Pano system is running the latest software.
  2. Connect one end of an HDMI cable to the HDMI Input port on the Pano system monitor.
  3. Connect the other end of the HDMI cable to an HDMI Output port on the Polycom video system.
  4. Connect one end of an HDMI cable to the HDMI Input port on the Polycom video system.
  5. Connect the other end of the HDMI cable to the HDMI Output port on the Pano system, as shown in the following figure:
    Pano System HDMI Out

  6. Configure your monitor profiles for your Polycom video system monitor:
    1. Open a browser and enter the IP address of the Polycom video system.
    2. Go to Admin Settings > Audio/Video > Monitors.
    3. For Monitor 1 at Monitor Profile, select Far, then Near.
    4. For Monitor 2 at Monitor Profile, select Content, then Far.
    The Pano system starts presenting content on the Polycom video system once the setup is complete. You must continue with the following steps to pair the systems and complete the setup.
  7. Open a browser and enter the IP address of the Pano system.
  8. Go to General Settings > Pairing.
  9. Enter the IP Address, Admin User Name, and Admin User Password that are associated with the Polycom video system. (If no password is set, leave the password field blank.)
  10. Select Connect, then select Pair.
    The Pair button displays only when the connection in the previous step is successful.
  11. Optional: Modify the Pano system name, then select Update.
  12. Test that content sharing functions properly.