Test Content Sharing

You can perform a test to confirm that content sent from a Pano system is displaying on a Polycom video system and vice versa. This is helpful when you are pairing systems from a remote location.

Procedure

  1. Open a browser and enter the system IP address using the format https://10.11.12.13.
  2. In the system web interface, go to General Settings > Pairing.
  3. Select Start Content for one or both of the following tests depending on your setup:
    • Test Content to RealPresence Group Series: Checks if the Pano system HDMI Output port is properly connected to the Polycom video system HDMI Input port. You can tell the test is successful without simulating a call if the Polycom video system enters a preview state.
    • Test Content to Pano: Checks if the Polycom video system Monitor 2 port is properly connected to the Pano system HDMI Input port. You can tell the test is successful without simulating a call if the Pano system screen displays content from the Polycom video system. If unsuccessful, an error message displays on the Pano system web interface indicating that no content is detected.
  4. When a test completes without errors, select Stop Content.