Configure IP Address Settings

You can configure IPv4 and IPv6 settings for the Pano system.

Procedure

  1. In the system web interface, go to Network > IP Addresses.
  2. Select one of the following options to specify how the Pano system gets its IP address:
    • Obtain IP address automatically
    • Enter IP address manually
  3. Configure the following IPv4 settings as needed:
    SettingDescription
    Your IP Address Displays the system IP address.

    If you need to create a static address, enter it here.

    This field is disabled if you set the IP Address field to Obtain IP Address automatically.

    Default Gateway Displays the gateway currently assigned to the system.

    If you need to create a static address, enter it here.

    This field is disabled if you set the IP Address field to Obtain IP Address automatically.

    Subnet Mask Displays the subnet mask currently assigned to the system.

    If you need to create a static address, enter it here.

    This field is disabled if you set the IP Address field to Obtain IP Address automatically.

  4. Configure the following IPv6 settings as needed:
    SettingDescription
    Enable IPv6 Enables the IPv6 network stack and makes the IPv6 settings available.
    Enable SLAAC Specifies whether to use stateless address autoconfiguration (SLAAC) instead of DHCP to automatically obtain an IP address.
    Link-Local Displays the IPv6 address used for local communication within a subnet.

    This setting is configurable only when you select Enter IP address manually.

    Site-Local Displays the IPv6 address used for communication within the site or organization.

    This setting is configurable only when you select Enter IP address manually.

    Global Address Displays the IPv6 Internet address.

    This setting is configurable only when you select Enter IP address manually.

    Default Gateway Displays the gateway currently assigned to the system.

    If the system does not automatically obtain a gateway IP address, enter one here.

    This setting is configurable only when you select Enter IP address manually.

  5. Select Save.