Change System Default Credentials

When you run the setup wizard, you are required to change your system's default password.


Before you begin, make sure that the monitor and network cables are connected and the power source is plugged in. A URL displays on the monitor once the Pano system is on.


  1. Open a browser and enter the system IP address using the format
  2. Change your system's default password.
    A new password is required to limit access to the system administrator settings. The default password, which is case sensitive, is the last six characters of your Pano system serial number.
    If you forget your administrator password, you must reset the system and run the setup wizard again to reset the password.
  3. Optional: Select the Change username checkbox to create a new username.
    The default username is admin.