Setting Up the Device

The TC8 device pairs with a Poly video system over your primary network. You can set up the device while you set up the video system or after you complete the video system setup.

If you purchased a TC8 device with your video system, the two automatically pair once you power on the device (the video system locates the device on the network by its MAC address). Once paired, the device’s local interface reflects the conferencing mode configured on your video system (for example, Poly Video Mode or Partner Mode).

There are situations where you must manually pair the TC8 device, such as adding or replacing a device with an existing video system setup.

For additional setup instructions, see the Poly TC8 Setup Sheet .