Call Hold Parameters

See the following list for the available parameters you can use to configure for Call Hold.

voIpProt.SIP.useRFC2543hold

0 (default) - SDP media direction parameters (such as a=sendonly) per RFC 3264 when initiating a call.

1 - the obsolete c=0.0.0.0 RFC2543 technique is used when initiating a call.

voIpProt.SIP.useSendonlyHold

1 (default) - The phone will send a reinvite with a stream mode parameter of “ sendonly ” when a call is put on hold.

0 - The phone will send a reinvite with a stream mode parameter of “ inactive ” when a call is put on hold

Note: The phone will ignore the value of this parameter if set to 1 when the parameter voIpProt.SIP.useRFC2543hold is also set to 1 (default is 0).
call.hold.localReminder.enabled

0 (default) - Users are not reminded of calls that have been on hold for an extended period of time.

1 - Users are reminded of calls that have been on hold for an extended period of time.

Change causes system to restart or reboot.

call.hold.localReminder.period

Specify the time in seconds between subsequent hold reminders.

60 (default)

Change causes system to restart or reboot.

call.hold.localReminder.startDelay

Specify a time in seconds to wait before the initial hold reminder.

90 (default)

Change causes system to restart or reboot.

voIpProt.SIP.musicOnHold.uri

A URI that provides the media stream to play for the remote party on hold. This parameter is used if reg.x.musicOnHold.uri is Null.

Null (default)

SIP URI