Content Sharing Parameters

Use the parameters in the following table to configure content sharing options.

To enable device pairing with the Polycom Trio solution, use the smartpairing* parameters. Note that People+Content IP does not support ultrasonic SmartPairing.

Table 1. Content Sharing Parameters

Template

Parameter

Permitted Values

Change Causes

Restart or Reboot

features.cfg

content.autoAccept.rdp

1 (default) - Content sent via Skype for Business Remote Desktop Protocol (RDP) by far-end users is automatically accepted and displayed on a near-end Polycom Trio solution.

0 - Near-end users are prompted to accept Skype for Business RDP content sent to Polycom Trio solution from a far-end user.

No

reg.cfg

content.bfcp.enabled

1 (default) - Enable content sharing by offering or accepting the Binary Floor Control Protocol (BFCP) in Session Description Protocol (SDP) negotiation during SIP calls. Does not apply to Skype for Business calls.

0 - Disable content sharing using BFCP.

No

features.cfg

content.bfcp.port

15000 (default)

0 - 65535

No

features.cfg

content.bfcp.transport

UDP (default)

TCP

No

site.cfg

mr.content.rdp.tls.enabled

Enable or disable TLS encryption of Skype for Business RDP content between hubs and devices.

1 (default)

0

No

site.cfg

mr.content.rdp.tls.enabled

1 (default) - Enable TLS encryption of Skype for Business RDP content between hubs and devices.

Disable TLS encryption of Skype for Business RDP content.

No

site.cfg mr.contentStreamPortEnd

The IP port range end port used for content input streams received from the Polycom Trio Visual+ system.

4320 (default)

1024 – 65436

No

site.cfg mr.contentStreamPortStart

The IP port range start port used for content input streams received from the Polycom Trio Visual+ system.

4300 (default)

1024 – 65436

No

reg.cfg

reg.x.content.bfcp.enabled

1 (default) - Enable Binary Floor Control Protocol content to be shared during calls for the line you specify.

0 - Disable Binary Floor Control Protocol content.

No

features.cfg

smartPairing.mode

Enables users with People+Content IP or Desktop on a computer or Mobile on a tablet to pair with the Polycom Trio conference phone using SmartPairing.

Disabled (default) - Users cannot use SmartPairing to pair with the conference phone.

Manual - Users must enter the IP address of the conference phone to pair with it.

No

features.cfg

smartPairing.volume

The relative volume to use for the SmartPairing ultrasonic beacon.

6 (default)

0 - 10

No